Table of Contents
Advertisement
Raising the vehicle at the rear
Pull out the adapter from the jack.
#
Position jack
4
at the jack support point of
#
axle carrier tube 6.
Keep pumping until axle carrier tube
#
securely in the jack support point and the
base of the jack lies evenly on the ground.
Raise the vehicle by pumping until the tyre is
#
no more than 3 cm off the ground.
Loosen and remove the wheel (
#
Removing a wheel
Requirements
The vehicle is raised (
R
When changing a wheel, avoid applying any force
to the brake disks, as this could impair the level of
comfort when braking.
* NOTE Damage to threading from dirt on
wheel bolts
Do not place wheel bolts in sand or on a
#
dirty surface.
Unscrew the wheel bolts.
#
Remove the wheel.
#
Fit the new wheel (
6
sits
#
Fitting a new wheel
Requirements
page 405).
/
R
page 403).
/
#
page 405).
/
For tyres with a specified direction of rotation, an
arrow on the side wall of the tyre indicates the
Wheels and tyres 405
The wheel is removed (
page 405).
/
& WARNING Risk of accident from losing a
wheel
Oiled or greased wheel bolts can cause the
wheel bolts to come loose, as too can dam-
aged wheel bolts or wheel hub threads.
Never oil or grease the threads.
#
In the event of damage to the threads,
#
contact a qualified specialist workshop
immediately.
Have the damaged wheel bolts or dam-
#
aged hub threads replaced.
Do not continue driving.
#
Observe the information on the choice of tyres
(
page 397).
/
Advertisement
Table of Contents
