Table of Contents
Advertisement
168 Driving and parking
Always make sure that nobody is within
#
the range of the garage door's move-
ment.
Before programming the garage door opener, park
the vehicle outside the garage. Make sure that the
vehicle is switched on but not started.
Requirements
The vehicle has been parked outside the
R
garage or outside the range of movement of
the door.
The vehicle is switched on.
R
The vehicle has not been started.
R
%
The garage door opener function is always
available when the vehicle is switched on.
Press and hold button 1,
2
#
wish to program.
Indicator lamp
4
flashes yellow.
%
It can take up to 20 seconds before the indi-
cator lamp flashes yellow.
Release the previously pressed button.
#
Indicator lamp
4
continues to flash yellow.
Point remote control
#
1 cm to 8 cm towards button 1,
Press and hold button
#
5
until one of the following signals appears:
Indicator lamp
R
ously. Programming is complete.
Indicator lamp
R
ming was successful. Additionally, syn-
chronisation of the rolling code with the
door system must be carried out.
If indicator lamp
#
green: repeat the procedure.
Release all of the buttons.
#
%
The remote control for the door drive is not
included in the scope of delivery of the garage
3
or
that you
door opener.
▌Synchronising the rolling code
Requirements
The door system uses a rolling code.
R
The vehicle must be within range of the garage
R
door or door drive.
5
from a distance of
2
or 3.
6
of remote control
4
lights up green continu-
4
flashes green. Program-
4
does not light up or flash
Advertisement
Table of Contents
