Mercedes-Benz G-Class 2022 Operator's Manual page 172

The vehicle as well as persons and objects are
R
located outside the range of movement of the
door.
Press the programming button on the door
#
drive unit.
Initiate the next step within approximately
30 seconds.
Press previously programmed button 1,
#
or 3 repeatedly until the door closes.
When the door closes, programming is com-
pleted.
% Please also read the operating instructions for
the door drive.
▌Troubleshooting when programming the remote
control
Check if the transmitter frequency of remote
#
control 5 is supported.
Replace the batteries in remote control 5.
#
Hold remote control 5 at various angles from
#
a distance of 1 cm to 8 cm front of the inside
rearview mirror. You should test every position
for at least 25 seconds before trying another
position.
Hold remote control
#
various distances in front of the inside rear
view mirror. You should test every position for
at least 25 seconds before trying another
position.
On remote controls that transmit only for a
#
limited period, press button
control 5 again before transmission ends.
2
Angle the aerial line of the garage door opener
#
unit towards the remote control.
%
It is possible that older garage doors cannot
be operated using the remote control in the
inside rearview mirror even after you have
successfully performed the measures descri-
bed above. If this is the case, contact the
®
HomeLink Hotline.
%
Support and additional information on pro-
gramming:
on the HomeLink
R
466 354 65 or +49 (0) 6838 907-277
on the Internet at https://
R
www.homelink.com
5 at the same angles at ▌Opening or closing the garage door
Requirements
R
#
6
on remote
#
▌Clearing the garage door opener memory
#
#
®
Hotline on (0) 08000
Driving and parking 169
The corresponding button is programmed to
operate the door.
Press and hold buttons 1, 2
door opens or closes.
If the indicator lamp 4 flashes yellow after
approx. 20 seconds: Press the previously
pressed button again and keep it pressed until
the door opens or closes.
Press and hold buttons 1 and 3.
Indicator lamp 4 lights up yellow.
If indicator lamp 4 flashes green: release
buttons 1 and 3.
The entire memory has been deleted.
or 3 until the