Environments And Installation; Environmental Conditions - Epson LS-B Series Manual

3. Environments and Installation

Designing and installation of the Manipulators and robotic equipment shall be performed
by personnel who has taken robot system training held by us and suppliers and should
conform to all national and local codes.

3.1 Environmental Conditions

A suitable environment is necessary for the robot system to function properly and safely.
Be sure to install the robot system in an environment that meets the following conditions:
Ambient temperature *
Ambient relative humidity
Fast transient burst noise
Electrostatic noise
Altitude
Environment
NOTE
Manipulators are not suitable for operation in harsh environments such as painting areas,

etc. When using Manipulators in inadequate environments that do not meet the above
conditions, please contact the supplier of your region.
* The ambient temperature conditions are for the Manipulators only. For the Controller
the Manipulators are connected to, refer to the Controller manual.
LS-B series Rev.5
Item
When the product is used in a low temperature environment around the minimum
temperature of the product specification, or when the product is suspended for a long
time on holidays or at night, a collision detection error may occur due to the large
resistance of the drive unit immediately after the start of operation. In such a case, it is
recommended to warm up for about 10 minutes.
LS20-B Manipulator 3. Environments and Installation
5 to 40°C
10 to 80% (no condensation)
1 kV or less (Signal wire)
4 kV or less
1000 m or lower
- Install indoors.
- Keep away from direct sunlight.
- Keep away from dust, oily smoke, salinity, metal
powder or other contaminants
- Keep away from flammable or corrosive solvents
and gases
- Keep away from water and oil.
- Keep away from shocks or vibrations.
- Keep away from sources of electric noise.
- Keep away from explosive area
- Keep away from a large quantity of radiation
Conditions
143