Chapte; Emoving And Installing Memo Y Boa Ds; Removing The Memory Board; Opening The Chassis - Intel SYSTEM 310 Configuration Manual

CHAPTE 5
EMOVING AND INSTALLING MEMO Y BOA DS
The steps in this chapter describe how to remove and install memory
boards in the System 310 chassis. Of the three memory boards
discussed in this manual, instructions are given for only two boards:
the iSBC 012B memory board and the iSBC 056 memory board. The
iSBC 304 R M Expansion MULTIMODULE Memory Board is part of
the iSBC 86/30 Single Board Computer hardware and its installation
is covered in the System 310 Processor Configuration Guide: 86/30
Single Board Computer.
Follow the steps in this chapter when you need to:
• Rearrange the boards in the system
• dd boards to or remove boards from the system
• Service a memory board
• Change the jumper settings
Removing or installing boards takes about 20 to 30 minutes to
complete.
WA NING
Unless you are a qualified service technician,
do not attempt to service any parts in this
system because of the risk of electrical shock.
You can safely handle only those boards and
jumpers that can be reached by removing the
back panel of the chassis.
EQUIPMEN YOU WILL NEED
Phillips screwdriver for #6 and #8 Phillips screws.
REMOVING HE MEMORY BOARD
The next three sections describe the major steps for removing the
memory boards from the System 310 chassis. Quite simply, you must
open the chassis, disconnect the cables, and remove the board.
WA NING
To guard against a risk of fire, always
disconnect the power cord before removing
the chassis back panel.
OPENING HE CHASSIS
1. Turn off the power, then remove the C power cord from the
back of the System 310 chassis.
5-1