Installing And Removing Memory - Intel NUC DC3217BY User Manual

Intel NUC Kit DC3217BY User Guide
This guide tells you how to:
Install and remove memory
•
Install a wireless card
•
Install an mSATA SSD
•
Install a VESA mount bracket
•
Install an operating system
•
Install the latest drivers
•
Open the Intel NUC Chassis
To open the Intel NUC chassis, follow these steps:
1. Unscrew the four corner screws on the bottom cover of the chassis and lift the cover.

Installing and Removing Memory

Intel NUC Kit DC3217BY has two 204-pin SO-DIMM sockets. Memory requirements:

1.5V DDR3 or 1.35V DDR3L (low voltage) memory
 1333 MHz or 1600 MHz SO-DIMMs
 Non-ECC
For a list of tested memory, go to the
Install SO-DIMMs
If you plan to install just one SO-DIMM, install it in the lower memory socket.
To install the SO-DIMMs, follow these steps:
1. Observe the precautions in "Before You Begin" on page 2.
3
System Memory page on the Support site: