Specific Absorption Rate Data - Nextel BlackBerry 6510 User Manual

• International Commission on Non-Ionising Radiation Protection (ICNIRP)
1998, Guidelines for limiting exposure to time-varying electric, magnetic, and
electromagnetic fields (up to 300 GHz)
To maintain compliance with FCC and IC RF exposure guidelines, use only RIM
supplied or approved accessories. The RIM handheld is designed to be carried in
an approved holster when carried on your body. When carrying the BlackBerry
Wireless Handheld while switched on, use the specific RIM holster that has been
tested for compliance. Use of non-RIM approved accessories may violate FCC and
IC RF exposure guidelines and may void your warranty.

SPECIFIC ABSORPTION RATE DATA

THIS MODEL WIRELESS HANDHELD MEETS GOVERNMENT
REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.
Your wireless handheld is a radio transmitter and receiver. It is designed and
manufactured not to exceed the emission limits for exposure to radio frequency
(RF) energy set by the Federal Communications Commission (FCC) of the U.S.
Government and Industry Canada of the Canadian Government (IC). These limits
are part of comprehensive guidelines and establish permitted levels of RF energy
for the general population. The guidelines are based on standards that were
developed by independent scientific organizations through periodic and
thorough evaluation of scientific studies. The standards include a substantial
safety margin designed to assure the safety of all persons, regardless of age and
health.
The exposure standard for wireless mobile handhelds employs a unit of
measurement known as the Specific Absorption Rate, or SAR. The SAR limit set
by the FCC/IC is 1.6W/kg.* Tests for SAR are conducted using standard operating
positions specified by the FCC/IC with the handheld transmitting at its highest
certified power level in all tested frequency bands. Although the SAR is
determined at the highest certified power level, the actual SAR level of the
handheld while operating can be well below the maximum value. This is because
the handheld is designed to operate at multiple power levels so as to use only the
power required to reach the network. In general, the closer you are to a wireless
base station antenna, the lower the power output.
Before a wireless handheld model is available for sale to the public, it must be
tested and certified to the FCC/IC that it does not exceed the limit established by
the government-adopted requirement for safe exposure. The tests are performed
in positions and locations (e.g., at the ear and worn on the body) as required by
the FCC/IC for each model. The highest SAR value for this model handheld when
Handheld User Guide
Important safety information
15