Figure 7-6. Canopy Seal Parts - GE Giraffe OmniBed Carestation CS1 Service Manual

6. Use the Enhanced Seal Retrofit Kit (M1208286) to replace the seal hardware.
7. Clean the canopy before reinstallation.
Refer to the following figure while performing the remaining steps in this section:
M4x16 buttonhead
socket cap screw
South rail
South seal
SW corner
cover
Spacer washer
West rail
M4 splitlock washer
M4x20 buttonhead socket
cap screw
8. Reassemble in reverse order. If alignment is required, refer to the
section.
Service Manual
SE corner cover
SOUTH
West seal

FIGURE 7-6. Canopy Seal Parts

Corner pin gasket
Corner pin
Corner receiver
M4x16 flathead Phillips screw with
pre-applied nylon patch
NW corner flange
M4x30
sockethead set
screw cup point
"7.6.1.1 Realigning the Canopy"
Chapter 7: Repair Procedures
Canopy Removal for Service
Smooth nut
Door support
Door support gasket
East seal
Rail spacer
East rail
NE corner
flange
North seal
North spacer
NORTH
(heater door end)
7-5