Figure 7-17. Soffit; Figure 7-18. Trimming The Soffit - GE Giraffe OmniBed Carestation CS1 Service Manual

Chapter 7: Repair Procedures
Canopy Removal for Service
Warning: The OmniBed must be properly reassembled per these guidelines. Improper
!
reassembly of the OmniBed may result in unsafe operation of the device.
16. Screw in the rail locking screws in the oblong slot in each rail to unlock the rails. Refer to
17. Realign the canopy as described in section 7.6.1.1.
18. Using a 2.5 mm hex key and four screws, reinstall the heater housing cover, securing it to the heater
door bracket.
19. Trim and reinstall the soffit:
a. Remove the north seal.
b. Locate two inside corners of ends of the soffit (6600-1461-500).
c. Mark approximately one eighth inch (3mm) by approximately 45º cut line at the inside corners
identified.
d. Cut corners with scissors or tin snips as marked.
7-14
Inside corners

FIGURE 7-17. Soffit

FIGURE 7-18. Trimming the Soffit

Figure 7-1.
Service Manual