Thermo Scientific Dionex TCC-100 Operating Instructions Manual page 35

An IP address and a subnet mask are required for the separate network adapter because the
TCP/IP protocol is used for the instrument LAN. The dialog box for entering the IP address
and the subnet mask is opened automatically during installation.
Please note: You can reopen this dialog box later if you need to change the IP address
and the subnet mask. Select the properties of the TCP/IP protocol via
Start → Settings → Control Panel → Network → Protocols. Then,
select the TCP/IP protocol and open the Properties of Microsoft TCP/IP
dialog box, using the Properties command on the context menu.
In the Adapter field, select the network adapter for the instrument LAN and enable the Specify
an IP address option.
Important: Do not change the settings for the office LAN network interface card!
Important: For the adapter for the instrument LAN, disable all other network
protocols and services (see above).
Assign a fixed IP address to the adapter for the instrument LAN.
First, identify which IP range is already used. To do so, open a DOS command box via
Start → Programs → Command Prompt and enter: Ipconfig /all. Differentiate between the
two following cases:
Case A: Already used IP address ≠ 192.168.60.xxx
Case B: Already used IP address = 192.168.60.xxx
Fig. 32: Assigning the IP address and subnet mask
29
TCC-100 Operating Instructions