Thermo Scientific Dionex TCC-100 Operating Instructions Manual page 24

TCC-100 Operating Instructions
• Installation of the eluent preconditioner is now complete.
• Install the column at an appropriate position in the column chamber.
• Connect the capillary from the autosampler or pump to the preconditioner inlet, connect the
preconditioner outlet to the column and then, connect the column outlet to the detector.
Capillary from the
preconditioner to
the column
Fig. 17: Eluent preconditioner with the capillaries connected (example)
Please note: Determine the direction of flow through the preconditioner as
Please note: For information about how to install the preconditioner with column
Please note: For information about how to connect the capillaries if a column
Fig. 15: Installed eluent preconditioner
Fig. 16: Column and eluent preconditioner installed
appropriate for your application, from the right to the left or vice versa.
clips, refer to section 3.6.2 (→ page 19).
switching valve is used, refer to section 3.7 (→ page 21).
Capillary from the column to the detector
18
Capillary from the
autosampler/pump to
the preconditioner