Thermo Scientific Dionex TCC-100 Operating Instructions Manual page 26

TCC-100 Operating Instructions
• Tighten the top parts of the preconditioner holders into place (→ Fig. 14, page 17).
• Install the column clips as shows in Fig. 21.
• Installation of the eluent preconditioner is now complete.
• Press the column into the clips.
• Connect the capillary from the autosampler or pump to the preconditioner inlet, connect the
preconditioner outlet to the column and then, connect the column outlet to the detector
(→ Fig. 17, page 18).
Please note: Determine the direction of flow through the preconditioner as
Please note: For information about how to install the preconditioner without column
Please note: For information about how to connect the capillaries if a column
Fig. 21: Installing the column clips
Fig. 22: Eluent preconditioner with column clips
appropriate for your application, from the right to the left or vice versa.
clips, refer to section 3.6.1 (→ page 17).
switching valve is used, refer to section 3.7 (→ page 21).
20