(6.1) Setting Drum Angle; (6.2) Leveling Windrower; Driveline Attachment - Schulte SRW800 Operator’s Manual With Parts Listing

6.1 Setting Drum Angle
The windrowing angle allows for the windrower to
windrow rocks at an angle. The hyrdaulic drum can be
angled from 0° to 18°. This allow the operator to windrow
the smaller rocks and not allow them to fall through the
gaps of the teeth. The Windrower can windrow rocks
from 2" to 25".
6.2 Leveling Windrower
To level windrower, ensure both casters have the same
number of washers below and above the sleeve.
Adjusting the number of washers so that the left end of
the drum sits lower then the right will allow the soil to
be feathered out while windrowing. For further
adjustment, adjust the lift arm on the lower 3PT hitch
arm.

7. DRIVELINE ATTACHMENT

The driveline yoke and tractor PTO shaft must be dirt
free and greased for attachment.
1. To connect the driveline to the tractor PTO output
shaft, twist driveline yoke collar and align the grooves
and splines of the yoke with those of the PTO shaft.
Push the driveline yoke onto the PTO shaft, release
the locking collar, and position the yoke until the locking
collar balls are seated onto the PTO shaft. Push and
pull the driveline back and forth several times to ensure
a secure attachment.
WARNING!
When attaching the PTO yoke to the Tractor PTO shaft, it is important that the spring
activated locking collar slides freely and the locking balls are seated securely in the
groove of the PTO shaft. A driveline not attached correctly to the Tractor PTO shaft could
slip off and result in personal injury and damage to the cutter.
SRW800 07/03
© 2003 Alamo Group Inc.
OPERATION
Hydraulic Cylinder
Operation Section 4-14