Drum Sprocket; Chain Tightener; Wheel Lock Pins - Schulte SRW1400 Operator's Manual

ASSEMBLY

Drum Sprocket

After locking the collars on drum end bearings, slide
big sprocket on shaft until it is against lock collar.
Insert hub and keys into sprocket.
Tighten hub by alternately tightening the three bolts
in hub. Tighten the bolts to 29 ft.-lbs. (39 Nm). Over
tightening will strip out bolts.
Slide the appropriate amount of machine bushings
until they are flush with end of shaft, then cap off
and tighten end bolt.

Chain Tightener

Align small sprocket to drum sprocket with machine
bushings. Tighten the set screws and install chain.
Finger-tighten the center M16 bolt for the Rosta
tightener into side plate.
Align tightener sprocket with other sprockets by
adjusting the half nuts.
Using the supplied wrench, preload the tightener
until the slot lines up with 1/2" bolt hole in the side
plate and the bolt can be inserted. Tighten both
bolts.

Wheel Lock Pins

The transport wheel lock pin comes equipped with
two holes for the snapper pin. When the rock
windrower is in transport position, the transport
wheel lock pin should be secured in the transport
position.
SRW1400 08/16 Assembly Section 3-3
© 2016 Alamo Group Inc.