Table of Contents
Advertisement
BEFORE OPERATION
•
Refer to the 'Maintenance' section of this manual for recommended oil type and viscosity.
•
Lubricate all grease fittings. Refer to the grease schedule in this manual.
•
Remove the chain case cover and check that the drive chain is properly tensioned and lubricated.
•
Refer to the 'Maintenance' section of this manual.
•
Check that all nuts and bolts are in place and properly tightened. Refer to the 'Maintenance' section of this
manual for proper bolt grades and torques.
•
Check all drive and hydraulic components are secure and free from damage.
Caster Wheel Adjustment (800 Series)
There is a 1" spacer on each caster wheel
assembly. To adjust the height of the casters, move
the spacer to the top or bottom of the wheel arm
depending on what height is desired.
Check tire inflation pressure. Tires should be
inflated to 45 PSI. Higher pressures may cause
excessive bouncing over rough ground.
SMR-600 04/21
© 2019 Alamo Group Inc.
ASSEMBLY
Assembly Section 3-2
Advertisement
Table of Contents
