Before Operation - Schulte SRW1400 Operator's Manual

ASSEMBLY

Before Operation

THE GEARBOX IS SHIPPED DRY. FILL WITH GEAR OIL BEFORE OPERATING.
Refer to the Maintenance Section of this manual for recommended oil type and viscosity.
Lubricate all grease fittings. Refer to the grease schedule in this manual.
Remove the chain case cover and check that the drive chain is properly tensioned and lubricated.
Refer to the Maintenance Section of this manual.
Check that all nuts and bolts are in place and properly tightened. Refer to the Maintenance Section of this
manual for proper bolt grades and torques.
Check that the pivoting wheel standard axle plates are set properly. The center of the lower 5/8" mounting bolts
must be set to a maximum 2-1/4" from the bottom of the pivoting wheel standard legs as shown below. A
setting higher than 2-1/4" may result in the tires contacting the drum.
Check tire inflation pressure. Tires should be inflated to 25 PSI. Higher pressures may cause excessive
bouncing over rough ground.
Gearbox output driveline should be installed with the shear bolt torque limiter at the gearbox.
SRW1400 08/16 Assembly Section 3-2
© 2016 Alamo Group Inc.