Maintenance And Service Safety Instructions And Practices - Schulte Titan 5000 II Series Operator's Manual

Only tow the Implement behind a properly sized and equipped Tractor
which exceeds the weight of the Implement by at least 20%.
tow the Implement behind a truck or other type of vehicle. Never tow the
Implement and another Implement connected in tandem. Never tow the
Implement at speeds over 20 MPH.
Secure the Implement for transport before traveling on public roads.
Implements, secure the center axle using cylinder stops or transport pin and properly attach
a safety chain between the Implement and Tractor. Secure wings in upright position on
folding Implements using wing transport locks.
Your driving vision may be reduced or impaired by the tractor, cab, or implement. Before
driving on public roadways identify any limited vision areas, and make adjustments to your
operating position, mirrors, and the implement transport position so that you can clearly
see the area where you will be traveling, and any traffic that may approach you. Failure to
maintain adequate vision of the public roadway and traffic can result in serious injury or
even death.
Raise the unit to the transport position and secure with the retaining pins before traveling
on public roads and when storing.

Maintenance and Service Safety Instructions and Practices

Relieve hydraulic pressure prior to doing any maintenance or repair
work on the Implement.
securely blocked up, disengage the PTO, and turn off the tractor
engine. Push and pull the Remote Cylinder lever in and out several
times. Disconnect and remove the Implement hydraulic hoses from
the tractor prior to starting any maintenance or repair work.
Always maintain the safety signs in good readable condition. If the safety signs are missing,
damaged, or unreadable, obtain and install replacement safety signs immediately.
Do not modify or alter this Implement.
Implement, any of its components or any Implement function.
Titan 5000 Series II 01/22
© 2022 Alamo Group Inc.
SAFETY
(STI-10)
(STL-15)
Place the Implement on the ground or
Safety Section 1-10
(STI-06)
(STI-7)
(STL-17)
Do not permit anyone to modify or alter this
(SG-8)
DO NOT
For pull-type
(SG-5)