GE PACSystems RXi User Manual page 174

Minor Error Codes for Major Error Code 90H (at Client Controller)
Error Status
(Hexadecimal)
0190H Timeout expired before transfer completed; still waiting on transfer.
0290H Period expired before transfer completed; still waiting on transfer.
8190H COMMREQ data block too short for the command.
8290H COMMREQ data block too short for server controller node address.
8390H Invalid server memory type.
8490H Invalid Program Name.
8590H Invalid Program Block Name.
8690H Zero server unit length is not allowed.
8790H Server unit length is too large.
8890H Invalid channel number.
8990H Invalid time unit for period. (Maximum permitted 3965 hours)
8A90H Period value is too large.
8B90H Zero server memory starting address is not allowed.
8C90H Invalid client memory type.
8D90H Invalid server host address type.
8E90H Invalid IP address integer value. (Must be 0–255)
8F90H Invalid IP address class. (Must be valid Class A, B, or C IP address)
May also occur if the destination IP address in the COMMREQ is same as the sender's IP address.
9090H Insufficient TCP connection resources to do request.
9190H Zero local starting address is not allowed.
9290H Address length value invalid. Must be 4 for address type 1.
9390H COMMREQ data block too short for Program Block name (including 0 pad).
9490H COMMREQ data block too short for Program name (including 0 pad).
9590H Internal API error. Refer to Controller Fault Table or exception log for details. This problem may occur due to the
Ethernet Interface being asked to perform beyond its capacity. Try transferring less data per message or
establishing fewer simultaneous connections.
9690H Underlying TCP connection aborted (reset) by server end point.
9790H Underlying TCP connection aborted by client end point.
9890H The remote server has no Service Request Processor.
9A90H Response to session request did not arrive in proper order.
9B90H Session denied by server controller.
9C90H Data response did not arrive in proper order.
9D90H Data response had unexpected size.
9E90H Unrecognized COMMREQ command code.
A190H Invalid CRS word memory type.
A290H Failed an attempt to update the CRS word.
A390H Reserved.
A490H Reserved.
A590H Reserved.
A690H Invalid bit mask.
A790H Unable to connect to remote device.
A890H Channel Resources in Use. Try the command again; a resource will become available.
A990H Establish Read/Write/Send Info Report Channel COMMREQ was received while an Abort was in progress.
GFK-2816F
Chapter 8. Gigabit Ethernet (GbE) Interface Overview and Operation
Error Description
August 2015 161