Graph Screen - Unipulse F805AT-BC Operation Manual

3.SCREEN LAYOUTS AND SETTINGS

3-3-3. Graph screen

Arithmetic values selected from belt speed, weight density, feed rate, load ratio, feed
ratio, and control rate are displayed either in bar graph or analog waveform. One of the
two graph formats is arbitrary chosen by pressing
rate can only be displayed in waveform.
【Bar graph】
Display select key
(pressing this button select comparison screen)
End point setting key
This button defines the bar graph end point
【Waveform】
Area for
Ch1 graph
Area for
Ch2 graph
Area for
Ch3 graph
14
Elapsed time
Goes to
comparison screen
Cursor ON/OFF Moves cursor
(effective only if cursor ON)
GRAPH TYPE
Graph select key
(pressing this button select waveform)
Bar graph Bar graph end point
Graph select key
(pressing this button select bar graph)
STARTs graph display
(the label changes to STOP
while the graph is being drawn)
. Note that control
Goes to
MODE
select screen
Bar graph area
Goes to
MODE
select screen
Y end point
Name of the
calculated value
Calculated value