Sequence Error - Unipulse F805AT-BC Operation Manual

11-8. Sequence Error

SEQ. ERR 1
The system has come to a halt because values for AT COORDINATE 1-4 and AT
COORDIN OUT 1-4 are not correct.
System operation cannot start in CONT.FEED RATE and CONT. TOTAL modes
unless these parameters are correctly specified. Run the auto coordinate mode (you can
also set these items manually).
SEQ. ERR 2
The system has come to a halt because control deviation over. This occurs if control
deviation exceeds, to the positive direction, the width of ALLOWABLE CONTROL
DEV. (CTRL. DEVIATION > ALLOWABLE CONTROL DEV.) for a period longer
than DEVIATION LIM.OVER ASC.
* This error is suppressed if either 0.0 or 999 seconds is set to DEVIATION LIM.
OVER ASC.
SEQ. ERR 3
The system has come to a halt because control deviation under. This occurs if control
deviation exceeds, to the negative direction, the width of ALLOWABLE CONTROL
DEV.(CTRL. DEVIATION < -ALLOWABLE CONTROL DEV.) for a period longer
than DEVIATION LIM.OVER ASC.
* This error is suppressed if either 0.0 or 999 seconds is set to DEVIATION LIM.
OVER ASC.
SEQ. ERR 4
The system has come to a halt because control limit over.
This occurs if control deviation exceeds the control limit (|control deviation| > |control
limit|) for a period longer than DEVIATION LIM.OVER ASC.
* This error is suppressed if either 0.0 or 999 seconds is set to DEVIATION LIM.
OVER ASC.
SEQ. ERR 5 (System Halt due to Belt speed over)
The system has come to a halt because during operation, OFL1 (Belt speed over) state
continued for a period longer than BELT SPEED OVER ASC.
* This error is suppressed if either 0.0 or 999 seconds is set to BELT SPEED OVER
ASC.
SEQ. ERR 6 (System Halt due to Weight density over)
The system has come to a halt because during operation, OFL2 (Weight density over)
state continued for a period longer than WEIGHT DENSITY OVER ASC.
* This error is suppressed if either 0.0 or 999 seconds is set to WEIGHT DENSITY
OVER ASC.
11.TROUBLESHOOTING
163