Using The Remote User Interface (Ui) - Christie CP2415-Xe Installation And Setup Manual

ID Port
A HDMI input 1 and HDMI input 2
B SDI input 1, SDI input 2, SDI input 3,
and SDI input 4
C DisplayPort (DP1 and DP2)
D Christie Link port
E Software-Defined Video over Ethernet
(SDVoE) port
F USB-C port
G Recessed button
H USB port
I Management port
J Marriage button
K Fire alarm connection
L RS232 communication port
M GPIO port
N 3D sync connector

Using the Remote user interface (UI)

Use the remote user interface (UI) to access projector functionality.
The Remote user interface (UI) is available as an accessory.
CP2415-Xe Installation and Setup Guide
020-103584-02 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Connecting devices and establishing communication
Description
Type A connector
HDMI v2.0 protocol supporting EDID 1.3 with HDCP v1.4 and 2.2
support
75 ohm Micro-BNC Connector
Multi-Rate SDI in accordance with SMPTE ST 259 (270Mb/s), ST
292-1 (1.5Gb/s), ST 424 (3.0Gb/s), ST 2081-1 (6Gb/s) and ST
2082-1 (12Gb/s)
Accepts digital video data from DisplayPort 1.2 input with HDCP 1.3
support.
Not used.
Not used.
Connects the projector touch panel.
Press the button to transition the projector from Standby mode to
Power ON mode.
Connects to external memory device for import and export of
projector software, configuration files, and status information.
Connects to the local network and can send CineLife+ serial
commands and used for Remote UI access.
Used during the IMB marriage setup process. See Activating IMB
marriage.
• Press and hold the button for 5 seconds to display the IP
address and status information.
• Press and hold the button for 30 seconds to reset the IP
address to the default address.
The marriage status LED indicator is located to the right of the
Marriage button. In full power mode, a green LED indicates the
projector is properly married and encrypted content can be
displayed. A red LED indicates marriage is broken and encrypted
content cannot be displayed.
Connects to the Theater Fire Management system for automatic
shut down in emergency situations.
Not used.
Connects the projector to external automation or automation
devices.
Connects the projector to 3D devices.
27