Installation - Siemens SINAMICS S120 Manual

Encoder system connection
9.12 DRIVE-CLiQ encoder
25°
20
Figure 9-59 Dimension drawing of hollow shaft, all data in mm
9.12.4

Installation

The installation surfaces and screws must be clean and free of grease.
Screw M4 - 8.8 with threadlocker (0.1 < thread friction coefficient < 0.16). Minimum screw-in
depth 6 mm. Please observe the hardening time for the threadlocker.
For a permitted surface pressure P
For replacement, recut thread M4 and use new screws with threadlocker.
Figure 9-60
314
±
47.2 0.5
0.5
D1
10H6
24
12H6
≤ 280 N/mm
G
Installation: Synchro flange
1
3.1
12.5
, use a washer.
2
Control Units and additional system components
Equipment Manual, 06/2020, 6SL3097-5AH00-0BP2
10.4