Table of Contents
Advertisement
Accessing the Tabletop Content Monitors
Using a Laptop
In all RPX suites, there is one tabletop content monitor available for every two
seats.
To access the tabletop content monitors:
Access the content monitors by removing the wooden covers located in
1
the tabletop.
Press the power button at the bottom right corner of each screen to power
2
on the content monitors.
Firmly pull up at the top of the content monitors to tilt the screen
3
forward.
To make room on the table, you can place the wooden covers behind the
4
content monitors.
When you are done using the content monitors, power them off, push
5
them back down, and replace the wooden covers.
If you want to share content that is stored on your laptop, you must connect
the laptop to the VGA and audio cable. You can access this cable from the cable
tray at the center of the main table.
Your system administrator may have set up your system so that content
automatically displays when you connect a laptop to the VGA cable. If so, you do
not need to use the Touch Panel to share content.
Enhanced User Interface
To view content with a laptop when you are using the Enhanced UI:
Access the VGA and audio cable in the cable tray.
1
Connect the VGA connector on this cable to the VGA Out connector on
2
your laptop.
Note that some laptops require you to enable VGA output (such as by
pressing Shift-F5). Refer to your laptop documentation for more
information.
If you want to transmit audio, connect the audio connector on this cable
3
to the Audio Line Out connector on your laptop.
Note that even if you want to send audio-only content, you must first
share video.
Viewing People and Content
3–7
Advertisement
Table of Contents
