Teledyne T3PM1100 User Manual page 8

Find Quality Products Online at:
(Note) EN 61010-1:2010 specifies the pollution degrees and their
requirements as follows. The T3PM1100 falls under degree 2.
 Pollution refers to "addition of foreign matter, solid, liquid, or
gaseous (ionized gases), that may produce a reduction of
dielectric strength or surface resistivity".
 Pollution degree 1: No pollution or only dry, non-conductive
pollution occurs. The pollution has no influence.
 Pollution degree 2: Normally only non-conductive pollution
occurs. Occasionally, however, a temporary conductivity caused
by condensation must be expected.
 Pollution degree 3: Conductive pollution occurs, or dry, non-
conductive pollution occurs which becomes conductive due to
condensation which is expected. In such conditions, equipment
is normally protected against exposure to direct sunlight,
precipitation, and full wind pressure, but neither temperature
nor humidity is controlled.
Location: Indoor
Storage

environment
Temperature: -40°C to 70°C

Humidity: <90%RH(non-condensing)

Do not dispose this instrument as unsorted
Disposal
municipal waste. Please use a separate collection
facility or contact the supplier from which this
instrument was purchased. Please make sure
discarded electrical waste is properly recycled to
reduce environmental impact.
8
GlobalTestSupply
www.
T3PM1100 User Manual
.com
sales@GlobalTestSupply.com