Teledyne T3PM1100 User Manual page 211

Find Quality Products Online at:
The transition filter parameters detect changes in the specified
condition register bits (numeric suffixes 1 to 16) and overwrite the
extended event register in the following ways.
Condition
RISE The specified extended event register bit is set to 1 when the
corresponding condition register bit changes from 0 to 1.
FALL The specified extended event register bit is set to 1 when the
corresponding condition register bit changes from 1 to 0.
BOTH The specified extended event register bit is set to 1 when the
corresponding condition register bit changes from 0 to 1 or
from 1 to 0.
NEVer Always zero.
The following table describes the Standard Event Register
Bit Name Decimal
0 Operation 1
Complete
1 Not Used 2
2 Query Error 4
3 Device Error 8
4 Execution 16
Error
5 Command 32
Error
6 Not Used 64
7 Power On 128
GlobalTestSupply
www.
Definition
Definition
All commands prior to and including
*OPC have been executed.
(Reserved for future use)
The instrument tried to read the output
buffer but it was empty. Or, a new
command line was received before a
previous query has been read. Or, both the
input and output buffers are full.
A device error, including a self-test error or
calibration error, occurred (an error in the -
300 range or any positive error has been
generated).
An execution error occurred (an error in
the -200 range has been generated).
A command syntax error occurred (an
error in the -100 range has been
generated).
(Reserved for future use)
Power has been cycled since the last time
the event register was read or cleared.
.com
APPENDIX
211
sales@GlobalTestSupply.com