4
General Maintenance
To Access the Left Side Lifting Handle
Left side cover
Front left grill
Figure 12.
Materials needed
•
The GC/MS interface, the analyzer parts, and the vacuum system operate at
WAR N IN G
temperatures high enough to cause serious burns. Give these parts enough
time to cool before accessing them or handling them.
Before performing this procedure, move the GC away from the MS. (See
Separate the GC from the MS"
down and disconnected from the building power supply. All gas lines must be
disconnected from the MS.
82
Remove covers to access the left side lifting handles
Screwdriver, Torx T-10 (8710-1623) or T-20 (8710-1615)
7250 Accurate-Mass Q-TOF Troubleshooting and Maintenance Manual
on page 76.) Both the GC and MS should be shut
"To