Agilent Technologies 7250 Troubleshooting And Maintenance Manual page 44

2 General Troubleshooting
•
•
•
•
•
•
•
•
•
•
44
Calibration vial empty or almost empty
Excessive pressure in the analyzer chamber
Air leak
MCP or PMT voltage is too low
Signal cable is not connected
Electrical leads to the detector are not connected correctly
Electrical leads to the ion source are not connected correctly
Filament shorted to the source body
Collision cell gas flow
Collision cell voltages
7250 Accurate-Mass Q-TOF Troubleshooting and Maintenance Manual