Table of Contents
Advertisement
Cautions to Be Taken When Driving the Machine
Cautions to Be Taken When Driving the Machine
·
If you operate the machine with the parking brake on, it
may cause serious damage to the parking brake disk.
·
Select the appropriate gear for the driving speed.
·
Do not change direction when driving the machine at
max. speed as this may cause serious damage to the
transmission.
·
Only drive the machine for short distances on the road.
·
Make sure you fully comply with the local road traffic
regulations and legislation of your country when driving on
the road.
·
Please note that the machine is wider and travels at a
lower driving speed than other vehicles on the roads.
·
Pay attention to any vehicles behind your vehicle, and
allow them to overtake your vehicle safely.
·
Check the following conditions before driving the machine
on the public road :
-
Remove any dirt and sand from the machine.
-
Empty the bucket and move it to the driving position (40~
50 cm above the ground) and fix it.
-
Close the windshield. Turn the working light off.
-
Wear the seat belt.
-
Use the lighting devices, such as the headlights, emergency
warning light and rotating beacon, pursuant to the local
road traffic legislation.
-
Pay attention to people in the vicinity of the machine.
-
Do not operate the machine on roads or bridges where
the machine exceeds the weight limit.
-
Familiarize yourself fully with the width, length and height
of the machine.
-
Check the tire pressure.
-
When traveling for a long distance, stop the machine
after every 40 km or on an hourly basis, and take a
break.
-
Check the level of fuel and coolant.
-
Never shift the gear to the neutral position when driving
down a slope.
-
Changing direction when operating the machine on a
slope is dangerous.
-
Do not drive on a slope of 30˚ or more.
-
Drive slowly when traveling the machine on rough terrain
or moving over obstacles.
-
Install chains on the tires when operating the machine
on slippery roads covered with snow or rainwater, and do
not attempt to start, stop or turn the machine suddenly.
-
Be sure to avoid any obstacles when traveling the
machine on paths.
Driving position
1-21
Advertisement
Table of Contents
