Table of Contents
Advertisement
23)
23)
HYDRAULIC OIL CHECK
HYDRAULIC OIL CHECK
Lower the bucket on the ground at a flat location
(1)
as in the illustration.
Stop the engine and then leave for about 5 min-
utes.
(2)
Check the oil level at the sight gauge. The sight
gauge is located on the left side of the hydraulic
oil tank.
(3)
The sight gauge should indicate the middle posi-
tion.
※
Add hydraulic oil, If necessary.
Add hydraulic oil, If necessary.
24)
24)
FILLING HYDRAULIC OIL
FILLING HYDRAULIC OIL
(1)
Stop the engine to the position of level check.
(2)
Rotate the cap nut counter-clockwise by hand
and push the rod to release the air pressure.
(3)
Remove the breather on the top of oil tank and
fill the oil to the specified level.
(4)
Start engine after filling and operate the work
equipment several times.
(5)
Check the oil level at the level check position after
engine stops.
Pushing
6-39
Sight gauge
930A6MI37
Cap nut
Rod
Air breather
930A6MI03
Advertisement
Table of Contents
