Table of Contents
Advertisement
Height adjustment (AIR SUSPENSION, OPT)
Height adjustment (AIR SUSPENSION, OPT)
(2) (2)
Fore/after adjustment
Fore/after adjustment
(3) (3)
Seat depth adjustment
Seat depth adjustment
(4) (4)
Seat pan angle adjustment
Seat pan angle adjustment
760F3CD152
①
The seat height can be set pneumatically and is
continuously adjustable.
②
The seat height can be altered by pulling or press-
ing the actuator lever fully out or in (arrow). If the
adjustment reaches the top or bottom endstop, the
height is adjusted automatically in order to guaran-
tee a minimum spring travel.
※
290F3CD30
Before adjusting the weight, adjust shock
Before adjusting the weight, adjust shock
absorbers to the position "soft".
absorbers to the position "soft".
※
In order to avoid damage, do not operate com-
In order to avoid damage, do not operate com-
pressor for more than 1 minute.
pressor for more than 1 minute.
①
The fore/after adjustment is released by lifting the
locking lever.
Do not operate the locking lever while operating.
Do not operate the locking lever while operating.
※
After the adjustment, the locking lever must latch
After the adjustment, the locking lever must latch
into the desired position with an audible click. It
into the desired position with an audible click. It
should not be possible to move the operator's
should not be possible to move the operator's
seat into another position when it is locked.
seat into another position when it is locked.
290F3CD258
※
Do not lift the locking lever with your leg or calf.
Do not lift the locking lever with your leg or calf.
①
The depth of the seat pan can be individually
adjusted.
②
To adjust the depth of the seat cushion, pull the
right handle upwards. By moving the seat pan back-
wards or forwards the desired seating position can
be reached.
290F3CD259
①
The angle of the seat pan can be individually
adjusted.
②
To adjust the angle of the seat pan, pull the left han-
dle upwards. By exerting pressure on or off the front
or rear part of the seat pan it can be moved to the
desired angle position.
290F3CD260
3-57-1
Advertisement
Table of Contents
