Hyundai HL930A Operator's Manual page 122

2) 2) GEAR SELECTOR LEVER GEAR SELECTOR LEVER
Acceleration
Deceleration
Forward
Backward
7803ACD36
3) 3) ACCELERATOR PEDAL ACCELERATOR PEDAL
760F3CD105
4) 4) BRAKE PEDAL BRAKE PEDAL
(Left)
760F3CD136
(Right)
(Left)
Dual brake(opt)
760F3CD137
5) 5) STEERING WHEEL STEERING WHEEL
Right
Left
760F3CD130
(1) This lever is used for gear selection, forward 4 stages and reverse 3
stages.
(2) If you push the gear selector lever, the machine moves forward, but
if pull the gear selector lever, the machine moves backward.
(3) If you turn the gear selector lever forward, the machine increases
the speed, but if you turn the gear selector lever backward, the
machine reduces the speed.
(1) This pedal controls the engine speed. The engine speed will
increase in proportion to the degree of force applied to this pedal.
(2) Unless this pedal is pressed, the machine will run at low idling.
(1) (1) Left brake pedal Left brake pedal (service brake + clutch cut off function)
①
If the pedal is pushed down, this will generate braking force and
bring the machine to a stop.
②
If the power train operation is to be cut off, set the clutch cut off
mode to ON (L , M, H) and press the pedal.
Even if the brake is applied while clutch cut off mode is OFF, Even if the brake is applied while clutch cut off mode is OFF,
power train will not cut off. power train will not cut off.
※
Do not operate the machine with foot the brake pedal unneces- Do not operate the machine with foot the brake pedal unneces-
sarily, or bring premature wear of brake disc. sarily, or bring premature wear of brake disc.
③
Clutch cut off function : Refer to page 3-20.
(2) (2)
Right brake pedal Right brake pedal (service brake function only)
This pedal functions as service brake only.
(1) Two multi-motion cylinders in the center of the machine will operate
the steering function.
(2) If the steering wheel is turned to left, the machine will move to the
left and turn it to the right, the machine will move to the right.
3-50