Hyundai HL930A Operator's Manual page 176

(7) (7) Stopping engine Stopping engine
※
If the engine is abruptly stopped before it has If the engine is abruptly stopped before it has
cooled down, its service life may be short- cooled down, its service life may be short-
ened. Avoid sudden stop except an emergen- ened. Avoid sudden stop except an emergen-
cy. cy.
※
When the engine is overheated, do not stop When the engine is overheated, do not stop
immediately. Run the engine at a mid range immediately. Run the engine at a mid range
speed to allow it to cool down, then stop it. speed to allow it to cool down, then stop it.
①
Check if the parking brake switch is ON.
②
Check if the gear selector lever is in the neutral
position.
③
Check if the pilot cut off switch is OFF.
④
Run the engine at low speed without operating
the equipment for about 5 minutes.
Turn the starting key to the OFF position and
remove the key.
Checks after the engine stopped Checks after the engine stopped
(8) (8)
①
Check the leakage of oil and water, the work
equipment and the exterior of the machine.
②
Refill the fuel tank.
③
Remove any debris inside of the engine room
and attached to the machine.
Gear selector lever
Pilot cut off switch
Parking brake switch
4-13
OFF
ON
Low idling
for 5 minutes
940A4OP20