Table of Contents
Advertisement
6. SERVICE INSTRUCTION
6. SERVICE INSTRUCTION
1) 1)
CHECK ENGINE OIL LEVEL
CHECK ENGINE OIL LEVEL
Check the oil level with the machine on a flat
ground before starting engine.
(1)
Pull out the dipstick and wipe with a clean cloth.
(2)
Check the oil level by inserting the dipstick com-
pletely into the hole and pulling out again.
(3)
If oil level is LOW, add oil and then check again.
※
If the oil is contaminated or diluted, change
If the oil is contaminated or diluted, change
the oil regardless of the regular change inter-
the oil regardless of the regular change inter-
val.
val.
※
Check oil level after engine has been stopped
Check oil level after engine has been stopped
for 15 minutes.
for 15 minutes.
Do not operate unless the oil level is in the
Do not operate unless the oil level is in the
normal range.
normal range.
2) 2)
REPLACEMENT OF ENGINE OIL AND OIL FILTER
REPLACEMENT OF ENGINE OIL AND OIL FILTER
(1)
Operate the engine until the coolant temperature
reaches 60˚C (140˚F). Shut off the engine.
(2)
Turn the stopper to the open position and allow
the oil to drain.
· Wrench size : 10 mm
※
A drain pan with a capacity of 30 liters (6.6
A drain pan with a capacity of 30 liters (6.6
U.S.gallons) will be adequate.
U.S.gallons) will be adequate.
Clean the area around the oil filter head.
(3)
Use oil filter wrench to remove the oil filter.
(4)
Clean the gasket surface of oil filter head.
(5)
※
The O-ring can stick on the filter head; make
The O-ring can stick on the filter head; make
sure it is removed.
sure it is removed.
Dipstick
O
C
(Open)
(Close)
Stopper
View A
6-15
Dipstick
Normal
930A6MI01
A
F u
e l
t a n
k
75796MI02
930A6MI03
Advertisement
Table of Contents
