Table of Contents
Advertisement
5. LOADING AND UNLOADING BY CRANE
5. LOADING AND UNLOADING BY CRANE
1)
Check the weight, length, width and height of the
machine referring to chapter 2, Specification
when you are going to hoist the machine.
2)
Use long wire rope and stay to keep the distance
with the machine as it should avoid to touch with
the machine.
3)
Put a rubber plate contact with wire rope and
machine to prevent damage.
4)
Place crane on the proper place.
5)
Install the wire rope and stay like the illustration.
Make sure wire rope is proper size.
Make sure wire rope is proper size.
Place the safety lock bar and pilot cut off switch
Place the safety lock bar and pilot cut off switch
to the OFF position to prevent the machine
to the OFF position to prevent the machine
moving when hoisting the machine.
moving when hoisting the machine.
The wrong hoisting method or installation of
The wrong hoisting method or installation of
wire rope can cause damage to the machine.
wire rope can cause damage to the machine.
Do not load abruptly.
Do not load abruptly.
Keep area clear of personnel.
Keep area clear of personnel.
Attach two wire ropes to the rear of the machine.
Attach two wire ropes to the rear of the machine.
Attach two wire ropes to the front of the machine.
Attach two wire ropes to the front of the machine.
Connect the four wire ropes.
Connect the four wire ropes.
Wire rope
Wire rope
5-6
Stay
Stay
Stay
REAR VIEW
940A5TA08
Advertisement
Table of Contents
