Table of Contents
Advertisement
3. LOADING THE MACHINE
3. LOADING THE MACHINE
1)
Load and unload the machine on a flat ground.
2)
Use the gangplank with sufficient length, width,
thickness and gradient.
3)
Move slowly and carefully when the machine is on
the gangplank.
Do not change the direction of the machine while
it is on the gangplank.
4)
Do the following after loading the machine to the
trailer.
(1)
Lower the working equipment gently after the
location is determined.
※
Place rectangular timber under the bucket cyl-
Place rectangular timber under the bucket cyl-
inder to prevent the damage of it during trans-
inder to prevent the damage of it during trans-
portation.
portation.
Do not operate any other device when load-
Do not operate any other device when load-
ing.
ing.
Balance the load.
Balance the load.
5-3
940A5TA12
940A5TA03
Advertisement
Table of Contents
