Hyundai HL930A Operator's Manual page 131

Hide thumbs Also See for HL930A:
Table of Contents

Advertisement

(5) (5)
Armrest (LH)
Armrest (LH)
Armrest (LH, RH)
Armrest (LH, RH)
1
2
(6) (6)
Armrest adjustment
Armrest adjustment
(7) (7)
Headrest
Headrest
The armrests can be folded up if required and the
height can be individually adjusted.
To adjust the armrest for height, separate the round
cap (see arrow) from the cover and loosen the
hexagon nut (size 13 mm) behind it adjust the
armrests to the desired position (5 steps) and
tighten the nut again (25 Nm).
290F3CD261
Replace the cap onto the nut.
1. Tilt lever
Pull up and hold to tilt armrest maximum 70 degrees.
2. Adjust lever
Pull up, hold and slide forward or rearward or up or down.
The inclination of the armrest can be modified by
turning the adjustment knob.
When turning the knob to the outside (+), the front
part of the armrest will be lifted; when turning the
knob to the inside (-), it will be lowered.
290F3CD262
The headrest can be individually adjusted for height
by pulling it upward over the various increments up
the end stop.
By pushing forwards or rearwards the angle of the
headrest can be adjusted individually.
To remove the headrest, pull it over the end stop.
290F3CD263
3-57-2

Advertisement

Table of Contents
loading

Table of Contents