Table of Contents
Advertisement
Operation on a slope
Operation on a slope
Comply with the following conditions when operating the
machine on a slope:
·
Do not work on slopes of 10˚ or more.
·
The maximum climbing angle of the machine on a slope
is 30˚. Do not operate the machine at an angle exceeding
this value.
·
If operation of the machine on a slope is unavoidable,
perform the work after flattening the ground.
·
When operating the machine laterally on a slope, there
is a high risk of machine overturning or slipping. Do not
operate the machine in such conditions.
·
Do not operate the machine on a slope covered with wet
grass or a thick layer of dead leaves, as the machine may
slip.
·
Do not park or stop the machine on a slope.
If parking or stopping the machine on a slope is
unavoidable, bring the bucket down to the ground, and
support the wheels with wheel chocks.
·
When traveling up a slope, operate the machine at a slow
speed with the attachment extended forward to keep the
machine balanced, and with the bucket raised at least 20
~30 cm from the ground.
·
Never travel down a slope in neutral. Keep the bucket
20~30 cm above the ground, and use the bucket as a
brake in an emergency situation.
·
If the engine suddenly stalls, immediately bring the bucket
to the ground.
·
If the fuel gauge reaches the red zone while operating
the machine, immediately refill with fuel. (If the machine
operates on a slope under these conditions, air may be
introduced into the engine, causing it to stall suddenly.)
1-20
Advertisement
Table of Contents
