Installing A So-Dimm Memory Module - Nexcom nROK 7251 Series User Manual

Chapter 4: System Setup

Installing a SO-DIMM Memory Module

For nROK 7251-7C4/nROK 7251-7A:
1. Loosen the screws on the heat sink and remove the heat sink.
Copyright © 2020 NEXCOM International Co., Ltd. All Rights Reserved.
2. Push the ejector tabs which are at the ends of the socket outward. Then
insert the module into the socket at an approximately 30 degrees angle.
Apply firm even pressure to each end of the module until it slips down
into the socket. The contact fingers on the edge of the module will almost
completely disappear inside the socket.
45
nROK 7251 Series User Manual