Emerson Micro Motion 9739 MVD Configuration And Use Manual page 58

Configure process measurement
June 2019
Option
A user-configured static
pressure value
A value written by
digital communications
Postrequisites
If you are receiving pressure data over the mA Input, ensure that the mA Input is configured for your
application.
If you are using an external pressure value, verify the setup by choosing Service Tools → Variables → External
Variables and checking the value displayed for External Pressure.
4.9.3 Options for Pressure Measurement Unit
The transmitter provides a standard set of measurement units for Pressure Measurement Unit. Different
communications tools may use different labels for the units. In most applications, Pressure Measurement
Unit should be set to match the pressure measurement unit used by the remote device.
Unit description
Feet water @ 68 °F
Inches water @ 4 °C
Inches water @ 60 °F
Inches water @ 68 °F
Millimeters water @ 4 °C
Millimeters water @ 68 °F
Millimeters mercury @ 0 °C
Inches mercury @ 0 °C
Pounds per square inch
Bar
Millibar
Grams per square centimeter
Kilograms per square centimeter
Pascals
Kilopascals
Megapascals
Torr @ 0 °C
58
Setup
a. Set Pressure Unit to the desired unit.
b. Set Compensation Pressure to the desired value.
a. Set Pressure Unit to the desired unit.
b. Perform the necessary host programming and communications setup
to write pressure data to the transmitter at appropriate intervals.
Display
FTH2O
INW4C
INW60
INH2O
mmW4C
mmH2O
mmHG
INHG
PSI
BAR
mBAR
G/SCM
KG/SCM
PA
KPA
MPA
TORR
Configuration and Use Manual
Label
ProLink III
Ft Water @ 68°F
In Water @ 4°C
In Water @ 60°F
In Water @ 68°F
mm Water @ 4°C
mm Water @ 68°F
mm Mercury @ 0°C
In Mercury @ 0°C
PSI
bar
millibar
g/cm2
kg/cm2
pascals
Kilopascals
Megapascals
Torr @ 0°C
Micro Motion 9739 MVD Transmitters
MMI-20016855
Field Communicator
ftH2O
inH2O @4DegC
inH2O @60DegF
inH2O
mmH2O @4DegC
mmH2O
mmHg
inHG
psi
bar
mbar
g/Sqcm
kg/Sqcm
Pa
kPa
MPa
torr