Installation; Reader/Writer - Omron V680S-HMD64-PNT User Manual

Section 4
Installation and Connections

Installation

Reader/Writer

 V680S-HMD63-PNT
Install the Reader/Writer with two M4 screws. Use both spring washers and flat washer.
M4 screw
Spring washer
Flat washer
When you install the Reader/Writer, prepare the metal plate shown in the following figure.
When the metal plates size is larger than the below illustration, communication range will change.
Material: Steel
Although it is possible to use SUS, aluminum or brass in addition to steel as the metal plate, communications range is
influenced by the material. Do not use resin as the metal plate.
The recommended tightening torque for M4 screws is 1.2 N·m.
Refer to Reader/Writer Installation Precautions in Section 11 Appendices for information of surrounding metal and Mutual
Interference of Reader/Writers.
p.252
RFID System
70
User's Manual
(PROFINET)
Two, M4 holes
42
±0.2
50
(Unit: mm)
Mounting Hole Dimensions
Two, M4 holes
42±0.2
V680S-HMD63-PNT
Screw mounting
Metal plate
(Unit: mm)