Installation; Reader/Writer - Omron V780 Series User Manual

4 Installation and Connections
4-1

Installation

This section describes the installation of the Reader/Writer and RF Tags.
4-1-1

Reader/Writer

V780-HMD68-ETN-/V780-HMD68-ETN--S
The Reader/Writer can be installed from the front or the rear.
 Front Mounting
Install the Reader/Writer with four M6 bolts. Use both spring washers and flat washers.
M6 bolt
Spring washer
Flat washer
 Rear Mounting
Install the Reader/Writer with four M6 bolts. Use both spring washers and flat washers.
M6 bolt
Spring washer
Flat washer
* If it is necessary to distinguish the appearance of the standard Reader / Writer (V780-HMD68-ETN-  / -EIP- )
and the slave Reader / Writer (V780-HMD68-ETN-  -S), please take measures such as attaching a non-metallic
label.
• Injury may occur if the Reader/Writer falls and strikes a person. When you install the
Reader/Writer, observe the tightening torque (4.3 N·m) for the M6 bolts.
Precautions for Correct Use
• An M6 bolt engagement length of 6 to 8 mm is necessary for rear mounting.
• The bolts may be hard to tighten. Tighten them to the recommended tightening torque.
4 - 2
Mounting Hole Dimensions
230±0.3
Four, M6 holes
Mounting Hole Dimensions
Four, 6.6-dia. holes
75±0.2
WARNING
UHF RFID System V780-series Reader/Writer User's Manual (Z389)
(Unit: mm)
(Unit: mm)