Host / Analog-Digital Signal Processor Module H11/H12 And A10; Host Board; Serial Port/Front Panel Board; Service Port (P1) - Novatech Bitronics M87X Series Manual

3.0 HOST / ANALOG-DIGITAL SIGNAL PROCESSOR MODULE H11/H12 AND A10

The Host/Analog-Digital Signal Processor Module is an assembly consisting of two
sections: the Host board and the Analog-Digital Signal Processor board.

3.1 Host board

The Host CPU module consists of a 486-class microprocessor, four communications ports
TM
and a CompactPCI
expansion via an optional Compact Flash card. The H12 host module utilizes a Compact
Flash card, available in optional sizes, and offers optional Ethernet interfaces (E1 and E3).

3.1.1 Serial Port/Front Panel Board

The Serial Port/Front Panel Board consists of the four serial driver connectors, four status
LED's, four bi-color serial port LED's, and a reset button. Port P1 is a PC-AT style 9-pin D
connector for the dedicated RS-232 port, and ports P2, P3, and P4 are universal 150-mil,
6-pin removable connectors for the RS-232/RS-485 serial ports. P2, P3, and P4 are
software (user) configurable for RS-232 or RS-485 mode. The RS-232 drivers support full
and half duplex modes. See Figures 3-6 (pg. 22 -26) for signal assignments.
3.1.1a Service Port (P1)
When connecting to the Service port DB9M (P1) from a PC, a null modem cable is
required. The Service Port can be used with a PC running a terminal emulation program.
Upon startup, the M87x default configuration sets P1 for 9600 baud, 8 data bits, no parity,
1 stop bit and no flow control handshaking. These parameters are user-configurable. A
small number of messages are sent to P1 and the M87x then outputs system messages.
Enter the command mode by pressing the ENTER key until the system outputs a
prompting message. Allowable commands are:
c:
cd
chp1
chp2
d:
date
del
dio point
display on
display off
Note: * This command is for UCA Goose only and is now referred to as GSSE.
Type "help <command>" to find out more about a particular command.
commonly used commands are:
ML0021
master bridge. The H11 host module offers non-volatile memory
Service Port\Zmodem Commands
dir
exit
getlog
Goose*
ip
mac
nsap
password
pulse
reboot
August 15, 2018
receive
reset
router
send
serial
setlog
subnet
software
receive
status
20
Copyright 2018 Bitronics, LLC
time
type
trigger dr1
trigger dr2
trigger wv1
trigger wv2
ver
whoami
vio point
The more