Novatech Bitronics M87X Series Manual page 151

Each input has two configurable jumper blocks.
hardware (the actual input circuitry), the other jumper control block configures the firmware
and software driver (informs drivers of the status of the hardware selection). It is extremely
important that when reconfiguring any input, that both the hardware jumper setting and
firmware jumper setting for that input match (select the same input type).
Figure 21 (P40 Input Type Jumper Locations) shows the location of each input's jumper
block pair. Each jumper block pair consists of two three pin headers and each header is
shipped with a shorting block. The position of the shorting block on the header determines
the input type configuration.
demonstrates the shorting block positions for the three valid input configuration options.
Figure 22 – P40 Input Type Jumper Configuration
ML0021
Input # 8
Input # 7
Input # 6
Input # 5
Input # 4
Input # 3
Input # 2
Input # 1
Figure 21 – P40 Input Type Jumper Locations
Figure 22 (P40 Input Type Jumper Configuration)
August 15, 2018
One jumper block configures the
0 - 10V
0 - 1mA
4 - 20 mA
135
Copyright 2018 Bitronics, LLC