Environmental; Physical; Hot Swap (Hs) Compatibility; Description - Novatech Bitronics M87X Series Manual

Input / Output Capacitance, any Terminal to Case:
Power Supply Requirements:
Hot Swap:

9.4 Environmental

Operating Temperature:
Relative Humidity:
Installation Category:

9.5 Physical

Connections:
Package:

9.6 Hot Swap (HS) Compatibility

The blue Hot Swap LED located on the front panel is illuminated to indicate when it is
permissible to extract a board in systems that support the Full Hot Swap System Model.
The M87x currently supports the Basic Hot Swap System Model. The Basic Hot Swap
System Model does not illuminate the blue LED. The blue LED will turn on briefly when a
card is inserted into an energized device or when the device is reset. If the blue LED
remains illuminated after insertion into an M87x or remains illuminated after the Host
module has booted, the associated card is malfunctioning.

9.7 Description

9.7.1 P30A

The Digital I/O Module consists of two circuit boards, the CompactPCI
(692), and the I/O Board (693). The Interface Board contains the CompactPCI
backplane connector and interface circuitry, front panel LEDs, and jumper blocks for output
relay power-up configuration.
ML0021
3.3Vdc, 5Vdc, +/-12Vdc (supplied from backplane)
P30A, P31 complies with Hot Swap specification PICMG 2.1
R1.0 for Basic Hot Swap (requires Host Processor re-boot)
-40C to 70C
0-95% non-condensing
IC III (Distribution Level), Pollution Degree 2. Refer to definition
on page 9.
Removable Terminal Blocks, accepts #16-28AWG (1,4-
0,09mm) wire. Recommended Torque Rating is 2.2 In-Lbs,
0.25 N-m. Standard 0.150" (3,81mm) header socket accepts
other standard terminal types. Solid core wire is
recommended, or stranded wire with the use of "bootlace
ferrules," where these are available.
P30A: CompactPCI
P31: CompactPCI
P33: CompactPCI
August 15, 2018
1400pF
TM
(3U, 4HP) removable module
TM (3U, 8HP) removable module
TM
(3U, 4HP) removable module
120
Copyright 2018 Bitronics, LLC
TM Interface Board
TM