Figure 116: Installing A T320 Sib - Juniper Core Router T Series Hardware Manual

See Also
Related
Documentation
Copyright © 2018, Juniper Networks, Inc.
Slide the SIB into the chassis, carefully ensuring that it is correctly aligned.
4.
Grasp both ejector handles and press them inward to seat the SIB.
5.
Tighten the captive screws on the ejector handles.
6.
Press the offline/online button until the green
7.
To verify that the SIB is functioning normally, check the LEDs on its faceplate. The
8.
green LED should light steadily a few minutes after the SIB is installed. If the
OK
LED is lit steadily, remove and install the SIB again. If the
the SIB is not functioning properly. Contact your customer support representative.
To check the status of the SIBs:
user@host> show chassis environment sib

Figure 116: Installing a T320 SIB

T320 Switch Interface Boards (SIBs) Description on page 85
Maintaining the T320 SIBs on page 286
T320 Switch Interface Boards (SIBs) Description on page 85
Maintaining the T320 SIBs on page 286
Chapter 29: Replacing Switch Fabric Components
LED blinks to bring the SIB online.
OK
FAIL LED still lights steadily,
FAIL
261