Connecting The T320 Router To An External Alarm-Reporting Device; Figure 59: Attach Cable To A Pic - Juniper Core Router T Series Hardware Manual
Hide thumbs
Also See for Core Router T Series:
- Monitoring and troubleshooting manual (812 pages) ,
- Handling instructions manual (12 pages)
Table of Contents
Advertisement
Related
Documentation
Connecting the T320 Router to an External Alarm-Reporting Device
Copyright © 2018, Juniper Networks, Inc.
CAUTION:
Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
CAUTION:
Do not let fiber-optic cable hang free from the connector. Do
not allow fastened loops of cable to dangle, which stresses the cable at
the fastening point.
Figure 59: Attach Cable to a PIC
T320 PIC Description on page 67
To connect the router to external alarm-reporting devices, attach wires to the
and
relay contacts on the CIP. A system condition that triggers the red
YELLOW ALARM
or yellow alarm LED on the craft interface also activates the corresponding alarm relay
contact.
Chapter 20: Connecting the T320 to External Devices
RED ALARM
155
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Core Router T Series and is the answer not in the manual?
Questions and answers