Installing A T320 Scg; Figure 69: Removing A T320 Scg - Juniper Core Router T Series Hardware Manual
Hide thumbs
Also See for Core Router T Series:
- Monitoring and troubleshooting manual (812 pages) ,
- Handling instructions manual (12 pages)
Table of Contents
Advertisement
See Also
Installing a T320 SCG
Copyright © 2018, Juniper Networks, Inc.
Figure 69: Removing a T320 SCG
Preventing Electrostatic Discharge Damage to a T320 Router on page 330
T320 SONET Clock Generator (SCG) Description on page 19
T320 SCG LEDs on page 20
Maintaining the T320 SCGs on page 273
To install a replacement SCG (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Carefully align the sides of the SCG with the guides in the SCG slot.
2.
Grasp the SCG by its handle and slide it straight into the chassis until it contacts the
3.
midplane.
Tighten the captive screws on the corners of the SCG faceplate.
4.
Chapter 24: Replacing Chassis Components
Figure 70 on page
188):
187
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Core Router T Series and is the answer not in the manual?
Questions and answers