Replacing A T320 Craft Interface; Removing A T320 Craft Interface; Figure 78: Installing The Rear Air Filter - Juniper T320 Hardware Manual

T320 Core Router Hardware Guide

Figure 78: Installing the Rear Air Filter

Related
Documentation

Replacing a T320 Craft Interface

Removing a T320 Craft Interface

158
Preventing Electrostatic Discharge Damage to a T320 Router on page 210
T320 Cooling System Description on page 44
Maintaining the T320 Air Filters on page 112
Troubleshooting the T320 Cooling System on page 132
Replacing the T320 Connections to Routing Engine Interface Ports on page 142
The craft interface is hot-insertable and hot-removable. When you install the craft
interface, allow several minutes for the display to reflect the current state of the router.
Before you remove the craft interface, remove the front upper fan tray. For instructions
on removing a front fan tray, see "Removing a T320 Front Fan Tray" on page 149.
Removing a T320 Craft Interface on page 158
1.
Installing a T320 Craft Interface on page 159
2.
The craft interface is located on the front of the chassis above the FPC card cage. The
craft interface weighs approximately 2 lb (0.9 kg).
Copyright © 2010, Juniper Networks, Inc.