Entering Configuration Mode; Configuring User Accounts And Passwords - Juniper Core Router T Series Hardware Manual

T320 Core Router Hardware Guide

Entering Configuration Mode

Configuring User Accounts and Passwords

168
NOTE: These procedures enable you to use the
port. For the initial configuration, use a device attached to the
on the CIP.
1. Entering Configuration Mode on page 168
Configuring User Accounts and Passwords on page 168
2.
Configuring System Attributes on page 169
3.
Committing the Configuration on page 170
4.
Verify that the network device is powered on.
1.
Log in as the root user. There is no password.
2.
Amnesiac <ttyd0>
login: root
Start the CLI.
3.
root@% cli
root>
Enter configuration mode.
4.
root> configure
Entering configuration mode.
[edit]
root#
For information about using an encrypted password or an SSH public key string (DSA or
RSA), see Configuring the Root Password and authentication (Login).
Add a password to the root administration user account. Enter a cleartext password.
1.
[edit]
root@host# set system root-authentication plain-text-password
New password: password
Retype new password: password
Create a management console user account.
2.
[edit]
root@host# set system login user user-name authentication plain-text-password
New Password: password
Retype new password: password
Set the user account class to
3.
.
super-user
Copyright © 2018, Juniper Networks, Inc.
management
ETHERNET
port
CONSOLE