Configuring A Member Switch - Allied Telesis AT-9000/28 Command Line User's Manual

Chapter 15: Enhanced Stacking

Configuring a Member Switch

awplus> enable
awplus# configure terminal
awplus(config)# vlan database
awplus(config-vlan)# vlan 12 name Tech_Support
awplus(config-vlan)# exit
awplus(config)# interface port1.0.4-port1.0.5
awplus(config-if)# switchport access vlan 12
awplus(config-if)#
awplus# show vlan
awplus# configure terminal
awplus(config)# estack run
284
This example shows you how to configure the switch as a member switch
of an enhanced stack. It configures the switch to be part of the same
enhanced stack as the command switch in the previous procedure. It does
this by creating the same common VLAN. Here are the specifications for
the member switch:
Common VLAN name: Tech_Support
VID: 12
Ports of VLAN: 4 and 5
1. This step creates the common VLAN.
end
2. Use the ESTACK RUN command in the Global Configuration mode to
activate enhanced stacking on the switch. It isn't necessary to set the
switch to the member mode because that is the default setting.
Enter the Privileged Executive
mode from the User Executive
mode.
Enter the Global Configuration
mode.
Enter the VLAN Interface mode.
Create the Tech_Support VLAN
and assign it the VID 12.
Return to the Global Configuration
mode.
Enter the Port Interface mode for
ports 4 to 5.
Add ports 4 and 5 to the
Tech_Support VLAN.
Return to the Privileged Exec
mode.
Verify the new VLAN.
Enter the Global Configuration
mode.
Activate enhanced stacking on the
switch.
Section II: Basic Operations